Per 
Item #: SCP-XXXX
Object Class: Euclid
Special Containment procedures: SCP-XXXX itself can be securely contained using any room larger that the dimensions of said SCP, however to contain any SCP that is to emerge from SCP-XXXX, special enhancements to the room must be made. Recommended specifications include at least 4 inch thick
steel walls and a coating of a heat proof organic polymer and ceramic compound over the steel, along with a small electrical circuit underneath the room connected to the floor. Damage to the interior should be monitored carefully using two remote cameras in opposite corners. Any attempt to damage either the cameras or the wall should be punished with a surge of electricity from the electrical circuit.
Description: SCP-XXXX is a brightly coloured and comically small motor vehicle, often referenced to as a "clown car". The car's dimensions are roughly 1.5m x 2.5m x 1m, bright yellow in colour with red dots around the entirety of the car with varying diameter. The windows of the car are tinted to the point where the speculation of whether the windows can be seen through at all from either sides has been made by multiple scientists working on SCP-XXXX. The car shows no signs of model type, or branding but through cross comparing the style of the car to the general style of cars over the years, SCP-XXXX has been estimated to have been made during the 1960s.
The reason for SCP-XXXX being classified as Euclid however is due to the multiple SCPs which can exit SCP-XXXX. Although being a small vehicle, a total of [DATA REDACTED] additional SCPs have been observed to leave the car, with the most commonly occurring being labelled as SCP-XXXX-1, SCP-XXXX-2 and SCP-XXXX-3. All SCPs are humanoid figures resembling clowns, all of which follow the same style and design of clowns from the previously estimated time interval. Each SCP is different in design, varying in height, width, colours of clothes, shoe size, glove size, and face paint. It should be noted that SCP-XXXX-1 is unique in that it wears a mask instead of face paint and any attempt to remove the mask has ended in failure and injury. The uniqueness of SCP-XXXX-1 has led scientists to believe that it may be the leader although further research is required to check this hypothesis. All SCPs are mute and are extremely aggressive towards any being that they visibly see, brandishing weapons and tools which they pull out of SCP-XXXX. These are abnormally adapted, increasing and decreasing in size at a comical and almost useless level. The weapons and tools range from knives or swords or slingshots to sledgehammers or even blowtorches, hence why such containment procedures are necessary, as the foundation is unable to efficiently confiscate any weapons or tools due to the seemingly limitless amount of tools that can be pulled out of SCP-XXXX as soon as one is confiscated. Other than aggression, the SCPs show practically no other behaviour (see addendum-1).
Addendum-1: The only time any of the SCPs have shown any other behaviour than aggression was during primary interviews. At this time, SCP-XXXX-1, SCP-XXXX-2, SCP-XXXX-3 and [DATA REDACTED] other SCPs were present. The brief of the interview was to understand whether any of the SCPs knew about other clown-like anomalies also contained by the foundation, primarily SCP-993 and SCP-2912. When asked about SCP-993 (named and referenced to in the interview as "Bobble"), most of the SCPs showed traits of joy, some even seemed to open their mouths and exhale violently, as if laughing. However when asked about SCP-2912 (SCPs were shown a picture of all three of SCP-2912), all SCPs showed behaviour similar to disgust and even fear. The SCPs then re-entered SCP-XXXX, not coming out until [DATA REDACTED]
Additional Links:
SCP-993: http://www.scp-wiki.net/scp-993
SCP-2912: http://www.scp-wiki.net/scp-2912
